FreeBSD Man Pages

badsect(8)

NAME

     badsect -- create files to contain bad sectors

SYNOPSIS

     badsect bbdir sector ...

DESCRIPTION

     The badsect utility makes a file to contain a bad sector.	Normally, bad
     sectors are made inaccessible by the standard formatter, which provides a
     forwarding table for bad sectors to the driver.  If a driver supports the
     bad blocking standard it is much preferable to use that method to isolate
     bad blocks, since the bad block forwarding makes the pack appear perfect,
     and such packs can then be copied with dd(1).  The technique used by this
     program is also less general than bad block forwarding, as badsect can't
     make amends for bad blocks in the i-list of file systems or in swap
     areas.

     On some disks, adding a sector which is suddenly bad to the bad sector
     table currently requires the running of the standard DEC formatter.  Thus
     to deal with a newly bad block or on disks where the drivers do not sup-
     port the bad-blocking standard badsect may be used to good effect.

     The badsect utility is used on a quiet file system in the following way:
     First mount the file system, and change to its root directory.  Make a
     directory BAD there.  Run badsect giving as argument the BAD directory
     followed by all the bad sectors you wish to add.  (The sector numbers
     must be relative to the beginning of the file system, but this is not
     hard as the system reports relative sector numbers in its console error
     messages.)  Then change back to the root directory, unmount the file sys-
     tem and run fsck(8) on the file system.  The bad sectors should show up
     in two files or in the bad sector files and the free list.  Have fsck(8)
     remove files containing the offending bad sectors, but do not have it
     remove the BAD/nnnnn files.  This will leave the bad sectors in only the
     BAD files.

     The badsect utility works by giving the specified sector numbers in a
     mknod(2) system call, creating an illegal file whose first block address
     is the block containing bad sector and whose name is the bad sector num-
     ber.  When it is discovered by fsck(8) it will ask ``HOLD BAD BLOCK ?''.
     A positive response will cause fsck(8) to convert the inode to a regular
     file containing the bad block.

SEE ALSO

     fsck(8)

DIAGNOSTICS

     The badsect utility refuses to attach a block that resides in a critical
     area or is out of range of the file system.  A warning is issued if the
     block is already in use.

BUGS

     If more than one sector which comprise a file system fragment are bad,
     you should specify only one of them to badsect, as the blocks in the bad
     sector files actually cover all the sectors in a file system fragment.

HISTORY

     The badsect utility appeared in 4.1BSD.

SPONSORED LINKS