FreeBSD Man Pages

lge(4)

NAME

     lge -- Level 1 LXT1001 NetCellerator PCI Gigabit Ethernet adapter driver

SYNOPSIS

     device miibus
     device lge

DESCRIPTION

     The lge driver provides support for various NICs based on the Level 1
     LXT1001 NetCellerator Gigabit Ethernet controller chip.

     The LXT1001 supports fiber PHYs and also a GMII port for use with
     10/100/1000 copper PHYs, however there are currently no NICs on the mar-
     ket that use this feature.

     The LXT1001 supports TCP/IP checksum offload for receive and VLAN-based
     filtering as well as a 64-bit multicast hash filter.  It also supports
     jumbo frames, which can be configured via the interface MTU setting.
     Selecting an MTU larger than 1500 bytes with the ifconfig(8) utility con-
     figures the adapter to receive and transmit jumbo frames.	Using jumbo
     frames can greatly improve performance for certain tasks, such as file
     transfers and data streaming.

     The lge driver supports the following media types:

     autoselect  Enable autoselection of the media type and options.  The user
		 can manually override the autoselected mode by adding media
		 options to rc.conf(5).

     1000baseSX  Set 1000baseSX operation over fiber optic cable.  Both
		 full-duplex and half-duplex modes are supported.

     The lge driver supports the following media options:

     full-duplex  Force full duplex operation.

     half-duplex  Force half duplex operation.

     For more information on configuring this device, see ifconfig(8).

HARDWARE

     Adapters supported by the lge driver include:

     o	 SMC TigerCard 1000 (SMC9462SX)
     o	 D-Link DGE-500SX

DIAGNOSTICS

     lge%d: couldn't map memory  A fatal initialization error has occurred.

     lge%d: couldn't map ports	A fatal initialization error has occurred.

     lge%d: couldn't map interrupt  A fatal initialization error has occurred.

     lge%d: no memory for softc struct!  The driver failed to allocate memory
     for per-device instance information during initialization.

     lge%d: failed to enable memory mapping!  The driver failed to initialize

SEE ALSO

     arp(4), miibus(4), netintro(4), ng_ether(4), ifconfig(8)

     Level 1 LXT1001 Programming Manual,
     http://www.FreeBSD.org/~wpaul/Level1/LXT1001SRM.pdf.

HISTORY

     The lge device driver first appeared in FreeBSD 4.4.

AUTHORS

     The lge driver was written by Bill Paul <william.paul@windriver.com>.

FreeBSD 5.4			August 24, 2004 		   FreeBSD 5.4

SPONSORED LINKS